Kramer Electronics PL-50 - Manual (Page 49)

Kramer Protocol 3000
45
ALERT-REG?
Cmd Short Description Command Type Permission
Query Alert Registration PL-50 User
Usage:
Syntax Response
ALERT-REG? CHNL ALERT-REG? CHNL ,EVENT ,ACTION
CHNL = (1-5)
EVENT = (TO_OFF,TO_ON,TO_FULL,TO_STBY,TO_NONE,ANY_CHANGE)
ACTION = (NO_ALERT,ALARM, ALL_ALERTS)
MEASURE
Cmd Short Description Command Type Permission
Device notification PL-50
Usage:
Syntax Response
MEASURE CHNL ,MES-MODE
Query the "full" and "standby" LED status. (device will report to all protocol ports on any change)
LVL = (0 = no LEDs, 1 = standby LED on, 2 = full LED on)
CHNL = (1-5)
MES-MODE= (0=MEASURE_START, 1 = MEASURE_DONE, 2 = MEASURE_TIMEOUT)
PWR-LVL?
Cmd Short Description Command Type Permission
Query Power level PL-50 User
Usage:
Syntax Response
PWR-LVL? PWR-LVL LVL
Query the "full" and "standby" LED status. (Device reports to all protocol ports on any change)
LVL = (0 = no LED, 1 = standby LED on, 2 = full LED on)
SCHED?
Cmd Short Description Command Type Permission
Query saved scheduling PL-50 User
Usage:
Syntax Response
SCHED? CHNL ,DAY SCHED? CHNL ,DAY ,SCHEDULINGS
CHNL = (1-5)
DAY = (1-7) OR (SUN,MON,TUE,WED,THU,FRI,SAT)
SCHEDULINGS = (start-end) example: 8:29-8:32
SWITCH
Cmd Short Description Command Type Permission
Channel switch PL-50 User
Usage:
Syntax Response
SWITCH CHNL ,STATUS SWITCH CHNL ,STATUS RESULT
CHNL = (1-5)
STATUS = (0=OFF,1=ON,2=ON-SCHEDULER,3=OFF-SCHEDULER ,4=ACTIVE-MEASURE,5=STANDBY-
MEASURE)