Kramer Electronics VM-30CA - Manual (Page 7)

Connecting the VM-30CA
5
5 Connecting the VM-30CA
To connect a VM-30CA unit as the example in Figure 2 illustrates, do the
following 1 :
1. Connect a component video source (for example, an HDTV satellite receiver)
to the Y, P
B
/C
B
, and P
R
/C
R
IN RCA connectors, and to the S/PDIF INPUT
RCA connector.
2. Connect 2 the:
Y, P
B
/C
B
, and P
R
/C
R
OUT 1 RCA connectors to the component video
acceptor (for example, a plasma display), and the digital audio S/PDIF 3
OUT 1 RCA connector to an AV-Receiver
Y, P
B
/C
B
, and P
R
/C
R
OUT 3 RCA connectors and the digital audio
S/PDIF
3
OUT 3 RCA connector to a home theater system (to which a
projector and speakers are connected)
3. Connect a 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 2).
4. If required, adjust 4 the audio level, the Y, P
B
/C
B
, and/or P
R
/C
R
output
signal level, and/or the Y, P
B
/C
B
, and/or P
R
/C
R
cable compensation
equalization level.
1 Switch OFF the power on each device before connecting it to your VM-30CA. After connecting your VM-30CA, switch on
its power and then switch on the power on each device
2 You can connect three component video output connectors to up to three component video acceptors. When less than three
outputs are required, connect only those outputs of the VM-30CA that are required, and leave the other outputs unconnected
3 Alternatively, connect the ANALOG AUDIO 3.5m socket (not shown in Figure 2)
4 Insert a screwdriver into the small hole and carefully rotate it, trimming the level