Kramer Electronics VM-80A - Manual (Page 11)

Connecting the VM-1610 and VM-80A
9
9
5. Adjust the right and left audio levels by turning the CH1 and CH2 LEVEL
trimmers with a small screwdriver.
To connect the VM-80A in a 2x1:4 configuration, do the following
1
1. Connect input source 1 (for example, a balanced stereo audio player) to the
CH 1 INPUT terminal block connector.
:
2. Connect input source 2 (for example, a balanced stereo audio player) to the
CH 2 INPUT terminal block connector.
3. Connect the CH 1 OUT terminal block connectors to up to 4 acceptors (for
example, balanced stereo audio recorders).
4. Connect the CH 2 OUT terminal block connectors to up to 4 acceptors (for
example, balanced stereo audio recorders).
5. Switch on the VM-80A.
6. Press the 2x1:4 MODE button.
The Channel 1 audio inputs are distributed to the Channel 1 audio outputs.
The Channel 2 audio inputs are distributed to the Channel 2/1 audio outputs.
7. Adjust the right and left audio levels by turning the CH1 and CH2 LEVEL
trimmers with a small screwdriver.
Figure 4: Connecting the VM-80A in a 1:8 Configuration
1 Switch OFF the power on each device before connecting it to your VM-80A. After connecting your VM-80A, switch on its
power and then switch on the power on each device