EZ Dupe Portable USB 2 Copy Duplicator & Tester - Manual (Page 10)

4.8 System Update
This function updates the system’s firmware version. Please save an un‐zipped update file to your
Flash device (DO NOT save the file in a folder). Insert the Flash device in slot (port #1) and select [8
System Update], press [OK], the system will automatically start to update firmware. When it finished,
turn the system off for 5 seconds and then turn it on, the new firmware will be upgraded.
5. Setup
5.1 Copy Area
There are two options for copy: Only Data Area and Whole Media.
Only Data Area: This function automatically analyzes the source Flash device’s file format. If the
format is FAT16, 32/NTFS/Linux (Ext2, Ext3) which is recognizable by the system, it will copy the data
only instead of copying the whole Flash device content. If the format is non‐recognizable, the system
will copy the whole Flash device including empty space. For example a 2GB Flash card which is FAT32
file format and has only 50 MB of data inside; the system will only copy that specific 50MB of data,
and will only take a few seconds to copy the source (master) device.
** The default setting of copy area is “Only Data Area”.
Whole Media: By setting up the duplicator to Whole Media function, the system will copy the whole
Flash devices content, including the empty space and format. This function is used when you have a
Flash source (master) which has an unknown file format and you don’t want the system to be
confused by such a format. For example a 2GB flash card which is FAT32 file format and has only 50
MB of data inside; if you setup “Whole Media” the system will copy the whole 2GB of content on your
Flash device. It will take much longer to copy the source.
5.2 Button Beep
You can select to hear a beep or not when you press the buttons.
5.3 Language
This function is to setup the language.
9