BrandTech Scientific HandyStep S - Manual (Page 32)

2
3
4
➠
➠
➠
Ejecting the PD-Tip
1.
Hold the HandyStep ® S over a vessel.
2.
Empty the PD-Tip by pushing the
locking/filling lever to its lower stop.
3.
Swing out the locking/filling lever
(the piston will then be decoupled).
4.
Hold the HandyStep ® S over the
waste container. Press the ejection
key down, releasing the cylinder.
The PD-Tip will be ejected.
Operation
Note:
The tightness of the seal of the PD-Tips
is not guaranteed for repeated dispen-
sing of high viscosity media.
Residues of the medium might be pres-
ent on the PD-Tip orifice. The PD-Tip
should only be ejected in a manner that
does not pose a hazard to the user or
other persons.
Warning!
32