Silverline 1500W 1/ Plunge Router - Manual (Page 9)

8
GB
Problem Possible cause Solution
Router will not operate
No supply of power Check that power is available at source
Brushes worn or sticking
Disconnect power, open Brush Access Covers (4) & (20). and ensure
brushes are not damaged or heavily worn
Switch is faulty Contact an authorised repair agent
Motor components faulty or short circuited Contact an authorised repair agent
Router runs or cuts slowly
Blunt or damaged cutter Resharpen or replace cutter
Variable Speed Dial (5) set low Increase variable speed setting
Motor is overloaded Reduce pushing force on router
Makes an unusual sound
Mechanical obstruction Contact an authorised repair agent
Armature has shorted sections Contact an authorised repair agent
Excessive vibration Bent or damaged cutter Replace cutter
Heavy sparking occurs inside
motor housing
Brushes not moving freely Disconnect power, remove brushes, clean or replace
Armature short circuited or open circuited Contact an authorised repair agent
Commutator dirty Contact an authorised repair agent
Fine Adjustment Knob (14)
“clicks” or not adjusting
Plunge Lock Lever (15) engaged Release Plunge Lock Lever
Reached end of adjustment range Reset Fine Adjustment Knob and set depth with Depth Stop Wheel (2)
Troubleshooting
The following chart contains information designed to assist in diagnosing
and resolving router problems.
264895_Z1MANPRO1.indd 8 05/11/2013 12:17