Silverline Rechargeable Torch 2 Million Candle Power - Manual (Page 7)

6
GB
Maintenance
Changing the bulb
1. Ensure the torch is not connected to either Charger (8 & 9)
2. Unscrew the Lens Ring (2)
3. Remove the lens unit and hold in one hand
4. With the other hand, squeeze together the two legs of the small
spring clip
Note: Pay attention to how it is fitted
5. Carefully lift the bulb out of the lens unit
6. Pull back the rubber sleeve, half way down the white wire, and
disconnect the plug
7. Taking care not to touch the glass (hold with clean tissue) re-fit the
new bulb by following this process in reverse
Cleaning
• Use a slightly damp cloth with a mild detergent to clean the torch
• Do not store in direct sunlight
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
Unpacking Your Tool
• Carefully unpack and inspect your tool. Fully familiarise yourself with all
its features and functions
• Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool
Before Use
IMPORTANT: The sealed lead acid battery in this product will be drained
from storage. The following steps must be taken to ensure it is charged
correctly. This will maximise the performance and working life of the
battery:
• Press the On/Off Switch (7) and check to see when the torch is On
• NOW MAKE SURE the product is switched OFF. The torch will only charge
in the OFF position
• Plug the Mains Charger (8) in to the mains power supply, and plug the
small end into the charging socket
• Leave to charge for a MINIMUM of 16 hours before first use
NOTE: If the torch fails to charge repeat the above, ensuring that the Switch
(7) is in the OFF position.
Fitting the Carry Strap
• Prise apart the Strap Links (4) and remove them from the torch body
• Thread them through the ends of the Strap (5)
• Re-fit the Strap Links (4) to the torch body. Squeeze together tightly and
check that they are secure
Operation
• Switch the torch on or off using the Switch (7)
• The Pistol Handle (6) can be twisted through 90 degrees by pressing the
Lock Button (3)
• Make sure the handle 'clicks' into position and is locked firmly
• To change the angle of the beam when the torch is surface mounted
adjust the Adjustable D-Stand/Handle accordingly
Charging
If the torch is not used on a regular basis, recharge after each use.
• Ensure the torch Switch (7) is OFF
• Mains Charger (8): Charge an empty battery for a minimum of 15 hours
• 12V Charger (9): Charge an empty battery for a minimum of 12 hours
1 Bulb
2 Lens Ring
3 Handle Lock Button
4 Strap Link (x 2)
5 Carry Strap
6 Pistol Handle
7 On/Off Switch
8 Mains Charger
9 12V Charger
10 Adjustable D-Stand/Handle
Product Familiarisation
123456_Z1MANPRO1.indd 6 30/07/2013 11:33