Comfort-Aire B-VFH18MA-1 - Manual (Page 9)

9
Heat Controller VFH InverterFlex ® - Indoor Ductless Mini-Split
Features and functions of wireless remote control
SLEEP
SLEEP button
Operation of wireless remote control
• When the initial set temperature is between 82°F-85°F
(28°C-29°C), the temperature will increase 1-2 degrees
every hour until a 1-2 degree increase is achieved and
that will be maintained for (7) hours. After (7) hours,
the temperature will decrease another 1-2 degrees and
continue to operate under this condition.
• When the initial set temperature is 86°F (30°C), after 7
hours the temperature will decrease 1-2 degrees and
continue to run under this condition.
Heat Mode:
• When the initial set temperature is set to 61°F (16°C),
the unit will maintain this temperature.
• When the initial set temperature is between 62°F-68°F
(17°C-20°C), the temperature will decrease 1-2 degrees
every hour until a 1-2 degree decrease is maintained.
• When the initial set temperature is between 69°F-81°F
(21°C-27°C), the temperature decreases 1-2 degrees
every hour, then this temperature is maintained.
• When the initial set temperature is between 82°F-86°F
(28°C-30°C), the temperature decrease 1-2 degrees
every hour until a 5-6 degree decrease has been
achieved. Then the unit will continue to operation under
this condition
Sleep 3 ( 3):
Allows customization of the Sleep mode conditions by
setting the temperature and hours it will be maintained
up to 8 hours. To create the individualized program under
the Sleep 3 mode, hold the turbo button until the remote
control displays “1 hour” and the set temperature will
display and blink “88”. Adjust the set temperature by
pressing the (+) or (-) buttons for the first hour of sleep
mode. Press the “Turbo” button to confirm. The remote
will advance to the next hour and display “2 hours” and
allow you to set the temperature again. After the set
temp is set, press the turbo button to confirm. Repeat
this process for the 8 hours of Sleep mode, setting
the temperature for each hour. After programming is
complete, the remote will resume it’s normal display.