Australian Monitor TXG 50 Speaker - Manual (Page 5)

4
TXG10 shown here
TXG50 shown here
PAGE 5 TXG SERIES INSTALLATION AND OPERATION MANUAL
REAR PANEL
1 Direct 8 Ohm Input
The TXG10 provides direct 8 Ohm connection via
this pair of spring loaded push terminals. When using
the 8 Ohm direct input terminals, the 6 W terminals
should not be used.
2 6W 100V Input
The TXG10 provides a 6 W 100 V input via this pair
of spring loaded push terminals. When using the
6 W 100 V input, the 8 Ohm terminals should
not be used.
3 Mounting Point
This thread point is used to attach the TXG10 to
the wall mounting bracket.
4 Voltage Tap Select Switch
This switch provides screw driver selection of the
desired 100 V transformer tap or the 8 Ohm low
impedance transformer bypass option.
5 Speaker Input
Speaker input is via a pair of colour coded binding
post terminals. The black terminal is negative, the red
terminal is positive.
6 Mounting Points
The wall bracket may be fitted to the mounting points
concealed by the plastic bungs fitted.
Remove these bungs prior to installing the wall bracket.
3
2
1
6
5
4
6