Australian Monitor VS84 - Manual (Page 6)

O P E R AT I O N
PA G E 6 V S 8 4 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
POWER
OUT-1
AV1
AV2
AV3
AV4
AV5
AV6
AV7
AV8
OUT-2 OUT-3 OUT-4
VS84
8 x 4 AV Switcher
Before making any connections to the VS84, observe the
following:
> Ensure the mains voltage supply matches the label on the supplied plug-
pack (+/- 10%)
> Ensure that the power switch is OFF Ensure that all system grounds (earth)
are connected to a common point.
> Avoid powering equipment within a system from multiple power sources
that may be separated by large distances
> Connect all audio video sources and destination equipment
> Power up all source and destination audio-visual sources
> Power up the VS84 AV matrix switcher
> For each destination output select the appropriate input source by using the
front panel UP and DOWN select button, the supplied IR remote control, or
through the RS232 serial communications port.
> Upon powering up the VS84 will return to it’s last used setting before
powerered down.
REMOTE CONTROL
The AMAV VS84 matrix switcher ships with a remote control. The remote
control has the following functionality:
i) Source Select Buttons
Four separate output assignment buttons are provided for each of the eight
AV input sources. The last selected input source will be routed to the destina-
tion output. Input sources may be assigned to multiple destination outputs.
ii) Power Button
Toggles the unit into, and out of, standby mode. In standby mode the matrix
switcher will stop AV routing. Standby mode is indicated by the illumination
of the front panel power LED only.
i
i i