Aussie WALK-A-BOUT 4280 - Manual (Page 4)

4
Set-Up Instructions
Step 1
Lay grill on its side. Place on grass or a
soft surface to prevent paint damage.
Step 2
Swing Pivot Latch away from the Leg
Crossrod to allow the legs to pivot.
Step 3
Swing Legs away from grill body until
they are straight out as shown.
Step 4
Grasp the inner leg near the grill body
and pull it toward the back of the grill.
Step 8
Install the Grease Cup in the Wire
Holder by reaching under the grill
and sliding the cup into the wire.
Replace the Cooking Grid.
Step 5
Slide the Leg Hook Wire on to the Bowl
Bracket until it stops at the back of the
Bracket. Be sure to allow the Safety Latch
to drop down behind the Leg Hook to
prevent the Hook from sliding off of the
Bracket.
Step 7
Install the Wire Grease Cup Holder by
first removing the Cooking Grid. Next,
holding the Wire by the small loop at the
top, thread the end down through the
small hole in the center of the bottom of
the grill bowl until the wire is hanging by
the small loop.
Step 6
Stand facing the top of the hood and
grasp the grill by the Control Panel
Handle and the hood flange at the rear.
Lift and rotate the grill until it is standing
upright on the ground.
Leg
Crossrod
Pivot Latch
Safety Latch
Leg Hook
Bowl
Bracket
Wire
Grease Cup
Holder
Grease Cup
PINCH HAZARD
To reduce the risk of bodily
injury from pinch hazard, keep
hands and fingers away from
hinges and leg pivot points.
Read and follow these instruc-
tions to set up your grill.
CAUTION
!