Care of sharpener – Edgecraft Chef's Choice eXact-V 415 User Manual

Page 8

tensioner (8) on the knife guiding assembly to its

bottom position. Note that the right side of the knife

guiding assembly must fit between the lock tab

(12) and the two standing ribs on the right. Insert

the guiding assembly on top of the rods with the

spring assembly facing up. Insert the bottom end of

the assembly’s post between the two large snaps

(adjacent the top end of the sharpening rods), then

lower and press the top end of the assembly down

and into position as shown in Figure 7. When this is completed the bottom cover

will fit and snap securely in place onto the bottom.You can lower the opened

hand guards by pulling them slightly upward, laying them flat and then sliding

forward to a locked position.

Care of Sharpener

The abrasive elements should always be used totally dry. Always wash and dry

knives before sharpening if they contain any food, oil or other material that can

be transferred onto the diamond abrasive surfaces.
If, however the abrasive surfaces become loaded with any foreign material, the

rods can be removed and their surfaces cleaned with a tooth brush and a mild

detergent/water solution. Clean the surfaces well and allow to dry completely.
Periodically clean the exterior surfaces of the sharpener with a soft damp cloth

to remove dust and any filings created by sharpening.

Limited Warranty: Used with normal care, this EdgeCraft product is guaranteed against defective material
and workmanship for a period of one (1) year from the date of original purchase (“Warranty Period”). We will
repair or replace, at our option, any product or part that is defective in material or workmanship without charge
if the product is returned to us postage prepaid with dated proof of purchase within the Warranty Period. This
warranty does not apply to commercial use or any product abuse. ALL IMPLIED WARRANTIES, INCLUDING
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO
THE WARRANTY PERIOD. EDGECRAFT CORPORATION SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSE-
QUENTIAL DAMAGES. Some states do not allow limitations on how long an implied warranty lasts and some
states do not allow exclusions or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you. This Limited Warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.

This product may be covered by one or more EdgeCraft patents and/or patents pending as marked

on the product.

A12

F602960

Figure 8.

Push here to

release post (6)

Push here to

release post (6)