Edgecraft Chef's Choice 120 - Manual (Page 12)

12
Assembled in the U.S.A. www.chefschoice.com
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on
the product.
Chef’sChoice
® , EdgeCraft ® , Diamond Hone ® , EdgeSelect ® and the overall design of the product are
registered trademarks of EdgeCraft Corporation, Avondale, PA
Conforms to UL Std. 982 Certified to CAN/CSA Std. C22.2 No. 64
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
© EdgeCraft Corporation 2014 Printed in China.
C14 C128200
®
EdgeCraft Corporation
825 Southwood Road, Avondale, PA 19311 U.S.A.
Customer Service 610-268-0500
NORMAl MAINTENANCE
No lubrication is required for any moving parts, motor, bearings or sharpening surfaces. There is
no need for water on abrasives. The exterior of the sharpener may be cleaned by carefully wiping
with a damp cloth. Do not use detergents or abrasives.
Once a year or so, as needed, you can remove metal dust that will accumulate inside the
sharpener from repeated sharpenings. Remove the small rectangular clean-out cover (Figure 14)
that covers an opening on the underside of the sharpener. You will find metal particles adhered
to a magnet attached to the inside of that cover. Simply rub off or brush off accumulated filings
from the magnet with a paper towel or tooth brush and reinsert the cover in the opening. If larger
amounts of metal dust have been created or if the Stage 3 disk has been cleaned (using the
cleaning/dressing means), you can shake out any remaining dust through the bottom opening
when the cover is removed. After cleaning, replace the cover securely with its magnet in place.
SERVICE
In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory where
the cost of repair can be estimated before the repair is undertaken. Outside the USA, contact your
retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of the
problem or damage on a separate sheet inside the box. Retain a shipping receipt as evidence of
shipment and as your protection against loss in shipment.
Figure 14. Clean-out cover.