Glastender Bottle Disintegration System - Manual (Page 4)

3
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
The BDS is shipped fully assembled in one carton.
Refer to photo right to identify the following:
1. Top cover
2. Door
3. Chute opening
4. Baffles
5. Indicator lights and ON/OFF switch
6. Casters
Start-up instructions:
1. Remove all packaging from around the main section.
2. Remove BDS unit from wood pallet and place on a firm,
level surface.
3. Remove all plastic protective paper from all stainless
steel parts.
4. The BDS must be installed in accordance with local
country electrical codes. A standard electrical supply
(120VAC only, 60HZ, 9.0A), properly grounded in
accordance with the National Electrical Code and local
codes and ordinances, is required.
5. Plug in BDS, place in position. BDS unit should be placed
up to a wall against the back bumpers (see Figure 1).
6. Lock the front casters, open the door, and assure that the
bucket is fully seated in the unit.
u
tility
r
equirements anD
c
onnections
u
ncrating anD
s
tart
-
up
i
nstructions
Electrical: 120 V single phase, 60 Hz, 9' grounded cord included. A dedicated 15 amp circuit is
recommended. Power requirements - 9.0 amps.
1
6
4
5
3
2
1. Unit must be located on a firm and level surface.
2. A 1/2" clearance above top is required for proper air flow to avoid
overheating the motor.
3. Unit must be installed in an area protected from the elements such as rain,
water spray, or drips.
4. Unit must NOT be located next to ovens, grills, or other high heat sources.
Figure 1
Bumpers
Back
Front