Glastender GT-30 - Manual (Page 23)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com 21
T
roubleshooTInG
G
uIde
T
rouble or
s
ITuaTIon
c
ause
r
emedy
O. Cold water runs contin- 1. Liquid level out of adjustment. 1. Remove obstruction or readjust.
uously, and sanitizer 2. Defective liquid level switch. 2. Test switch and replace if
pump is functioning necessary.
P. Cold water runs contin- 1. Cold water inlet valve 1. Clean or replace cold water
uously, but sanitizer not seating properly. inlet valve.
pump turns on and off
Q. Heater glowing 1. Wash tank water valve 1. Replace valve.
not opening.
2. Liquid level switch stuck 2. Replace switch.
in closed position.
R. Detergent and/or 1. Detergent and/or sanitizer 1. Refill or replace container(s).
sanitizer not feeding container(s) are empty.
properly 2. Feed lines will not fill. 2. Replace defective parts.
Notes: The detergent or sanitizer
product advances in the line on
each stroke of the pump. The
product should hold position
between strokes. If the product
falls back toward the supply
container, one or more of the fol-
lowing conditions may exist:
a. Debris in pump,
b. Split feed line, or
c. Bad pump tube.
Replace parts as necessary.
S. Poor washing results 1. Clogged spray nozzles and 1. Clean unit. See cleaning
dirty wash tank. instructions, pg. 17-18.
2. Detergent container empty. 2. Fill container.
3. Poor water conditions. 3. Have filter or softener installed.
4. Chemicals not adjusted 4. Call chemical technician.
properly.
5. Curtains not installed properly. 5. Install curtains properly.
T. Glasses are “sudsy” 1. Iodine-type sanitizer used. 1a. Re-adjust iodine solution.
1b. Replace with chlorine bleach
(sodium hypochlorite - 5.25%
solution).