Minka Group F802-ORB - Manual (Page 17)

8
WARNING: WARNING: Shut of the power supply before removing or replacing lamp. In handling of halogen bulb, care should be taken not to touch it with
your bare hands. Oil residue will shorten the life of the halogen bulb. If you accidentally come into contact, wipe thoroughly with a clean,
lint-free, cotton cloth. Allow the bulb to cool off for 10 minutes before changing the bulb. Use light bulb in accordance with the fan's specification.
TO REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM WATTAGE RATING.
ATTENTION: ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the
ceiling fan's light kit will shut off automatically.
1. Install the 100w halogen bulb (included). (Fig. 17)
2. Place glass shade into light plate, align the three flat sections from the glass neck with the three raised dimples from the light plate. Press glass
into light plate and gently turn clockwise until it stops and feels snug, do not over tighten. (Fig. 17)
CAUTION: CAUTION: hold the edges of the glass with both hands and very gently wiggle it up and down to make sure is properly secured and it won't come off
easily. (Fig. 17)
NOTE: NOTE: A metal light cap has been included with your fan as an option to replace the glass in the event that you prefer not to use the light feature of
your fan. This metal light cap is not necessary for the light operation. It can be saved for later use if desired.
INSTALLING THE LIGHT BULB AND GLASS SHADE