Minka Group F803-SL - Manual (Page 20)

11
Fig. 20
WARNING: Shut off the power supply before removing or replacing lamp. In handling of
halogen bulb, care should be taken not to touch it with your bare hands. Oil residue will shorten
the life of the halogen bulb. If you accidentally come into contact, wipe thoroughly with a clean,
lint-free, cotton cloth. Allow the bulb to cool off for 10 minutes before changing the bulb. Use light
bulb in accordance with the fan's specification. TO REDUCE THE RISK OF FIRE DO NOT EXCEED
MAXIMUM WATTAGE RATING.
ATTENTION: ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
Step 1. Install 100W halogen bulb (included). (Fig. 20). (Disregard this step if using the optional
switch cup cover)
Step 2. Raise glass shade or optional switch cup cover up against bottom of fan housing and secure
it to fan by turning it clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 20)
Note: If installing the optional switch cup cover, make sure is securely tighten.
INSTALLING THE LIGHT BULB & GLASS SHADE
BULB
LIGHT PLATE
GLASS SHADE
OR OPTIONAL
SWITCH CUP
COVER