Minka Group F637-WHF - Manual (Page 15)

8
NOTE: NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.
ATTENTION: ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the
ceiling fan's light kit will shut off automatically.
Step 1. Remove 1 of 3 screws from the mounting ring and loosen the other 2 screws. (Do not remove)
(Do not remove)
Step 2. Place the key holes from the light kit mounting plate over the 2 screws previously loosened from the mounting ring, turn light kit mounting
plate until it locks in place at the narrow section of the key holes. Secure by tightening the 2 screws previously loosened and the one
previously removed. (Fig. 17)
Step 3. Remove the screws from the edge of light kit mounting plate. While holding the light kit, firmly snap the wire molexes together. Next, slide
switch cup up against plate and rotate it until the screw holes are aligned. Secure light kit to switch cup plate using the screws removed
earlier. (Fig. 18) Make sure the connectors are properly connected and that non of the single wires is pushed out of the plastic connectors.
Step 4. Install 3 x 60w candelabra base bulbs (included).
Step 5. Remove the metal plate, glass cap and finial from the light kit. Raise the glass shade up against the light kit stem, Place the metal plate with
rubber on the top over the stem and turn it clockwise until it locks up against the glass shade. Do not overtighten. Do not overtighten. (Fig. 19)
Step 6. Raise the glass cap and final against the glass shade and secure it to the stem by turning the final clockwise until snug. Do not overtighten. Do not overtighten.
(Fig. 19) Note: Note: Make sure to leave enough space between the fan pull chain and the bulbs so the chain doesn't rub against any of the bulbs.
LIGHT KIT INSTALLATION