Team Associated ProLite 4x4 - Manual (Page 12)

12
:: Spur Gear Access - (cont.)
:: Spur Gear Access - (cont.)
:: Spur Gear Access - (cont.)
Spur Gear Maintenance:
When accessing your spur gear, check for wear on the
teeth of the gear. The teeth should be nice and sharp.
Also, check the slipper pads for wear.
Replace if necessary.
A good starting point for slipper setup is to have 3.5 to
4.0mm of thread showing on the shaft.
Slipper Pads
Slide center bulkhead
cap forward to remove
slipper assembly!
3.5mm-4.0mm of
thread showing