Dynalab SI80/120V/60 - Manual (Page 5)

3
using the short hex wrench. Release the
adjusting screws and adjust until the desired
angle is obtained and then lock off the
adjusting screws. Lock off the locking screws
on the drive boss.
5. Switch the motor back on and check
operation.
Adjustment of Tilt Angle - SI80
1. Position the unit with its left side facing
forward.
2. Remove the white plastic cap located in the
centre at the bottom of the unit.
NOTE: The mains power needs to be
connected during adjustment so care
must be taken not to touch anything but
the parts in the instruction below. All the
live electrical parts are mounted on the
front panel so are well away from the
area of concern.
3. Turn the speed control to its slowest setting
and, looking through the hole, watch for the
black Allen screw to come into view. Stop the
motor when it is directly facing you.
4. Using the tool provide with the rocker,
unscrew the Allen screw by two
turns.Remove the tool and rotate the motor
by 180° and stop it when the silver headed
slot screw is directly facing you.
5. Turn the screw clockwise until tight. This
method increases tilt. Continue the above
until the desired tilt is achieved.
6. To reduce the tilt, turn the screws in the
opposite direction in the opposite sequence,
i.e. undo the slot headed screw & tighten the
Allen screw.
Maintenance & Servicing
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
The following spares and accessories are available
from your laboratory dealer.
Description Cat
Number
Spare securing bar (SI50) RSI50
Blue Dyson non-slip mat (SI70 & 80) KS0305
Spare platform tier (SI70 & 80) SI700090
For a comprehensive list of parts required by
service engineers conducting internal repairs and
a service manual, please contact the Technical
Service Department of Barloworld Scientific Ltd.
quoting both the model and serial number.
Only spare parts supplied or specified by
Barloworld Scientific Ltd. or its agents should be
used. Fitting of non-approved parts may affect
the performance and safety features designed
into the instrument.
If in any doubt, please contact the Technical
Service Department of Barloworld Scientific Ltd.
or the point of sale.
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail [email protected]
www.barloworld-scientific.com