Dynalab SB162-3 - Manual (Page 5)

Servicing and Repair
This product range does not require any routine
servicing.
Note: There are no internal user
replaceable parts.
In the event of product failure it is recommended
that any repair is only undertaken by suitably
qualified personnel. For advice or to receive a
service manual please contact the Technical
Service Department of Barloworld Scientific Ltd.
Only spare parts supplied by Barloworld Scientific
or its agent should be used. Fitting of non-
approved parts may affect the performance of
the safety features of the instrument.
Note: The magnetic stirrer drive utilises
strong magnets.
If in doubt, please contact the Technical Service
Department of
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail [email protected]
www.barloworld-scientific.com
Spares
The following spare parts are available from your
laboratory supplier. For a comprehensive parts
list please contact the Technical Service
Department of Barloworld Scientific Ltd quoting
model and serial number.
Description Catalogue
Number
Control knob SB160/CK
Rubber feet, set of 4 SB160/RF
Retort rod, CS10
Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of two (2)
years. In the event of a justified claim
Barloworld Scientific will replace any defective
component free of charge.
This warranty does NOT apply if any repair has
been made or attempted other than by
Barloworld Scientific or its agent.
3