MEGUIAR'S G132 - Manual (Page 3)

G132 - NXT Generation Speed Detailer
Fire-fighters should wear appropriate protective equipment and self-contained
breathing apparatus (SCBA) with a full face-piece operated in positive pressure
mode. Special protective
equipment for fire-fighters :
Environmental precautions
Personal precautions
Stop leak if without risk. Move containers from spill area. Approach the release from
upwind. Prevent entry into sewers, water courses, basements or confined areas.
Wash spillages into an effluent treatment plant or proceed as follows. Contain and
collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite
or diatomaceous earth and place in container for disposal according to local
regulations (see section 13). Dispose of via a licensed waste disposal contractor.
Contaminated absorbent material may pose the same hazard as the spilt product.
Note: see section 1 for emergency contact information and section 13 for waste
disposal.
6. Accidental release measures
:
: No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilt material. Avoid breathing vapour or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment (see section 8).
Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Large spill :
Stop leak if without risk. Move containers from spill area. Dilute with water and mop
up if water-soluble or absorb with an inert dry material and place in an appropriate
waste disposal container. Dispose of via a licensed waste disposal contractor Small spill :
Handling
Handling and storage
Storage
7.
Put on appropriate personal protective equipment (see section 8). Eating, drinking
and smoking should be prohibited in areas where this material is handled, stored and
processed. Workers should wash hands and face before eating, drinking and
smoking. Do not ingest. Avoid contact with eyes, skin and clothing. Avoid breathing
vapour or mist. Keep in the original container or an approved alternative made from a
compatible material, kept tightly closed when not in use. Empty containers retain
product residue and can be hazardous. Do not reuse container.
Packaging materials
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible
materials (see section 10) and food and drink. Keep container tightly closed and
sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabelled containers.
Use appropriate containment to avoid environmental contamination.
:
:
Recommended : Use original container.
Recommended monitoring
procedures If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness
of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to European Standard EN 689 for
methods for the assessment of exposure by inhalation to chemical agents and
national guidance documents for methods for the determination of hazardous
substances.
8. Exposure controls/personal protection
A respirator is not needed under normal and intended conditions of product use. Respiratory protection :
:
Occupational exposure
controls : No special ventilation requirements. Good general ventilation should be sufficient to
control worker exposure to airborne contaminants. If this product contains ingredients
with exposure limits, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure below any recommended or statutory
limits.
Exposure controls
Date of issue : Page: 3/6 04/30/2008 Version 3