MEGUIAR'S M03 - Manual (Page 4)

M03, Machine Glaze (original formulation): M0316, M0364
__________________________________________________________________________________________
Page: 4 of 14
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
For industrial or professional use only. Do not handle until all safety precautions have been read and understood. Do not
breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when
using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.)
Use personal protective equipment (eg. gloves, respirators…) as required. Vapours may travel long distances along the
ground or floor to an ignition source and flash back.
7.2. Conditions for safe storage including any incompatibilities
Store away from areas where product may come into contact with food or pharmaceuticals. Store away from acids. Store
away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Silica, crystalline (airborne
particles of respirable size) 14464-46-1 Health and
Safety Comm.
(UK)
TWA(respirable):0.1 mg/m3
Glycerin 56-81-5 Health and
Safety Comm.
(UK) TWA(as mist):10 mg/m3
Silica, amorphous 68855-54-9 Health and
Safety Comm.
(UK)
TWA(as inhalable dust):6
mg/m3;TWA(as respirable
dust):2.4 mg/m3
Paraffin Wax 8002-74-2 Health and
Safety Comm.
(UK) TWA(as fume):2
mg/m3;STEL(as fume):6
mg/m3
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection