MEGUIAR'S M23 - Manual (Page 4)

M23, Professional Odour Eliminator (20-137A): M2301
__________________________________________________________________________________________
Page: 4 of 12
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Formaldehyde 50-00-0 Health and
Safety Comm.
(UK) TWA:2.5 mg/m3(2
ppm);STEL:2.5 mg/m3(2 ppm)
Propan-2-ol 67-63-0 Health and
Safety Comm.
(UK) TWA:999 mg/m³(400
ppm);STEL:1250 mg/m³(500
ppm)
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
None required.
Respiratory protection
Wear respiratory protection if ventilation is inadequate to prevent overexposure.
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Clean and fresh odour; Clear, water-thin liquid
pH 9 - 9.9
Boiling point/boiling range 100 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point >= 93.3 ºC [Test Method:Closed Cup] [Details:ASTM D56]
Autoignition temperature No data available.