MEGUIAR'S M49 - Manual (Page 5)

M49, Hard Water Oxidation Remover (11-83D): M4916, M4965
__________________________________________________________________________________________
Page: 5 of 11
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Sweet odour; White, viscous, semi-pourable lotion
pH Not applicable.
Boiling point/boiling range 198.9 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point > 93.3 ºC [Test Method:Pensky-Martens Closed Cup]
[Details:D93-90]
Autoignition temperature No data available.
Flammable Limits(LEL) No data available.
Flammable Limits(UEL) No data available.
Vapour pressure No data available.
Relative density 1 [Ref Std:WATER=1]
Water solubility Negligible
Partition coefficient: n-octanol/water No data available.
Evaporation rate No data available.
Vapour density No data available.
Viscosity 8 - 16 Pa-s
Density 1 g/cm3
9.2. Other information
Volatile organic compounds (VOC) 14.26 % weight
VOC less H2O & exempt solvents 418.14 g/l
SECTION 10: Stability and reactivity
10.1 Reactivity
This material may be reactive with certain agents under certain conditions - see the remaining headings in this section
10.2 Chemical stability
Stable.
10.3 Possibility of hazardous reactions
Hazardous polymerisation will not occur.
10.4 Conditions to avoid
Temperatures above the boiling point.