MEGUIAR'S M86 - Manual (Page 4)

M86, Cut & Polish Creme (22-99A): M8601, M8632
__________________________________________________________________________________________
Page: 4 of 15
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dykes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a toxic, corrosivity or flammability hazard. Collect as much of the spilled material as possible.
Place in a closed container approved for transportation by appropriate authorities. Clean up residue with detergent and water.
Seal the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area or areas with little or no air movement. Keep out of reach of children. Do not breathe
dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this
product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Vapours
may travel long distances along the ground or floor to an ignition source and flash back.
7.2. Conditions for safe storage including any incompatibilities
Store away from heat. Protect from sunlight. Store away from areas where product may come into contact with food or
pharmaceuticals. Store away from acids. Store away from oxidising agents. Store away from strong bases.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Aluminium oxide 1344-28-1 Health and
Safety Comm.
(UK) TWA(as inhalable dust):10
mg/m³;TWA(as respirable
dust):4 mg/m³
Silica, crystalline (airborne
particles of respirable size) 14808-60-7 Health and
Safety Comm.
(UK)
TWA(respirable):0.1 mg/m3
Glycerin 56-81-5 Health and
Safety Comm.
(UK) TWA(as mist):10 mg/m3
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls