MEGUIAR'S MC200 - Manual (Page 4)

MC200, Motorcycle Cleaner (20-35C): MC20016
__________________________________________________________________________________________
Page: 4 of 10
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
No occupational exposure limit values exist for any of the components listed in Section 3 of this Safety Data Sheet.
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Wear eye/face protection.
The following eye protection(s) are recommended: Indirect vented goggles.
Skin/hand protection
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Respiratory protection
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Pleasant odour; Clear, watery liquid
pH 7 - 7.5
Boiling point/boiling range 100 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point >=93.3 ºC [Test Method:Pensky-Martens Closed Cup]
[Details:D93-90]
Autoignition temperature Not applicable.
Flammable Limits(LEL) Not applicable.
Flammable Limits(UEL) Not applicable.
Vapour pressure No data available.
Relative density 1.00 [Ref Std:WATER=1]
Water solubility Complete