Aussie Joey 7110.7.641 - Manual (Page 7)

Step 4) Install Drip Cup:
Insert Drip Cup into Drip Cup Holder ring (installed
in bottom of Grill Body) until the cup flange is
flush with the ring
(17) DRIP CUP
Step 3) Assemble Hood/Bowl to Cart:
(15) BOLT, M6X45
4 PC
(16) M6 LOCKNUT
4 PC
FIG. 3A
FIG. 3C
(16) BOLT, M6X45
(15) M6 Nut
(14) HOOD/BOWL ASSEMBLY
Bowl Bracket Legs
7
Bowl/Leg Bolts
Left and Right
Sides
FIG. 3B
View Inside Bowl
NOTE: REQUIRES 2-PERSONS
· With Cart upright, align Bowl Bracket legs with
Cart legs. (FIG. 3A)
· Lower Hood/Bowl so ends of Cart legs insert
into Bowl Bracket legs.
· Press downward until leg screw holes align.
NOTE: If cart legs do not align and fit into
Bowl Bracket legs easily, loosen the Control
Panel bolts slightly. Then open the Hood and
loosen the 2-Bowl/Leg bolts on either, or
both sides of the Bowl. (FIG. 3B)
· Insert M6x45 Bolts from the outside through
the legs and tighten with M6 Locknuts.
(FIG. 3C)
· Re-tighten all Bolts.
Control Panel
Bolt on each
side of grill