SMS Audio SYNC by 50 - Manual (Page 3)

Refer to this guide for button descriptions and
locations of other features mentioned throughout
the manual.
Button Locations & Descriptions SYNC by 50 On-Ear Bluetooth®
Audio Cable
RIGHT EARCUP
SIDE
Powering On/Off:
To turn on: push power/pairing switch to center position. A tone will
sound indicating the power is on and LED light will begin to blink.
To turn off: push power/pairing switch to off position. LED light will
stop blinking.
Connecting Your Device:
1. Make sure your device is in Bluetooth® discovery mode.
2. When power is on and LED light is blinking, pull down and hold the
power/pairing switch in the SYNC position for approximately 3 seconds.
The LED will begin to flash rapidly.
3. Release the power/pairing into the center position and choose ‘SYNC
by 50’ on your pairing device (New phones will connect automatically –
some phones may require password ‘0000’ to be entered).
4. Once connected, the next time the SYNC by 50 On-Ear Bluetooth®
headphone is turned on, it will automatically connect to your device.
Getting Started
Remove cable.
Fold one side then the other.
On/Off & Pairing Mode
Volume Up
Play/Pause & Answer/End
Track Forward
Track Back
Volume Down
2
4
6
3
5
1
ON BOARD CONTROLS
FOLDING YOUR
HEADPHONES
3.5mm
Audio Jack
Micro USB
Port
EARCUP BOTTOMS
Microphone
Call Answer /
Audio Control button
AUDIO CABLE
*The audio/mic cable is compatible with
iPod ® , iPhone ™ and iPad ™ .
SYNC by 50 On-Ear Bluetooth®