KEMP R Series - Manual (Page 6)

Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 6 / 25
LoadMaster for the Dell R-Series
LoadMaster for UCS Installation
Installation Guide
2 Connect the Dell R-Series
Here is some information about the Dell R-Series ports:

Eth0 to eth5 = 1GB copper Network Interface Cards (NICs)

Eth6 and eth7 = 10GB SFP+ ports
To connect the Dell R-Series, follow the steps below:
1. Install the Dell R-Series into a 19 inch rack or another safe location.
2. Connect Ethernet cables to the ports on the Dell R-Series. Please use the worksheet
included in the pack to determine which ports to connect. For single-arm setups, the
switch only needs to be connected to port 0.
3. Connect the monitor and keyboard to the Dell R-Series (or just a serial cable).
4. Connect the power cable to the Dell R-Series.
5. Turn on power to the unit.
The installation then completes as shown in Figure 2-1.
Figure 2-1: Installation Complete