Power on the loadmaster, Virtual loadmaster for kvm, 3 power on the loadmaster – KEMP KVM User Manual
Page 7
Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 7 / 17
Virtual LoadMaster for KVM
Installation guide
MAC Addresses
Enter the MAC address and network bridge information for each NIC required in the installation.
slot='0x03'function='0x0'/>
2.3 Power On the LoadMaster
To start the VLM, from within the location where you unzipped the KVM zip file, type the
following command:
virsh create
This starts the VLM boot process.
Administrator permissions are required to run these commands.
Figure 2-1: IP address
The VLM should obtain an IP address via DHCP. Make a note of this address.