Rhin-O-Tuff HD4170 - Manual (Page 6)

Issue “0” Part # 941000 www.RHIN-O-TUFF.com
Overview of the HD-4170 Rhin-O-Roll;
See Illustration 2.0 on next page.
The HD-4170 has many useful features to increase your coil binding productivity.
- Adjustable Lower Roller:. The Adjustable Lower Roller supports the
lower side of the coil while binding. The Adjustable Lower Roller is also
referred to as “Roll” in item 4 in “Book Thickness Coil Selector and Roll
Position Setting”.
- Upper Roller: The soft Upper Roller grabs the coil and spins it into the
book quickly and effectively.
- Doc-U-Form Book Former: allows you to form your book to allow for
quick starting and binding of large books. See Chapter 3 for further
explanation and use of this feature.
- Book Thickness Coil Selector and Roll Position Setting: This multi-
use feature allows you to slide your uncoiled book into its thickness gauge
and suggests the appropriate coil size to use for that job. As well as giving
you the suggested Lower Roll position setting, it provides the answers to
sizes and pitch of stray coils and punched sheets. See Chapter 3 for
further explanation and use of this feature.
- Power Switch: This switch turns the HD-4170 on and off. Pushing on
the I symbol side of the switch turns the machine ON, the O turns the
machine OFF. On 230VAC models this is on the rear of the machine. It is
recommended you turn the machine off when not in use. In case of any
emergency use the power cord as the main power Cutoff!!!
-Crimping Pliers: Used for cutting and crimping coil ends.
-Crimping Pliers Holder: A convenient place to store your pliers.
-Roll Position Setting: Shows the current location of the Adjustable
Lower Roller. See Chapter 3 for further explanation and settings of this
feature. The “Thumb Pull” image shows the intended location of your
thumb while pulling on the Adjustment Knob with your index and middle
fingers to change settings of the Lower Roller.
-Adjustment Knob: Pull and move up or down to change the position of
the Adjustable Lower Roller.
-Fuse Holder: Not shown, located on rear of machine. Always replace
fuses with the correct amperage and type (PDI P/N 007072 115VAC or
001659
230VAC
);
9 115VAC use; 1ea. FUSE,3 AMP AGC ¼” X 1 ¼”
9 230VAC use; 2ea. FUSE,1.5 AMP GMA M5 X 20MM
5