Rhin-O-Tuff OD3500 - Manual (Page 4)

Forward /off / reverse switch
The forward / off / reverse (8) switch has three positions. The center
position of this switch is the off position and should be placed in this
position when not using the machine. Press the left side (forward) of the
switch and the coil will rotate into the book. Press the right side (reverse)
of the switch and the coil will exit the book. The reverse feature allows the
coil to be removed from the book. Sometimes this will be necessary when
the leading edge of the coil misses a hole of a single sheet.
Inserting a coil.
Diagram 5c
Place the coil on the mandrel by sliding the open end of the coil onto the
beveled end of the mandrel. Turn the coil so it threads onto the mandrel
post (9) and is in front of the drive wheel by one coil. Make sure the
forward / reverse switch is in the forward position. Pull the handle (10)
down to start the motor and engage the drive wheel (11) to the coil.
Rotate the coil so it comes close to the edge of the book, but not past the
book. With your right hand, hold the leading edge of thecoil and thread it
through the first two holes of the book. This helps align the holes of the
book. Rotate the lexan guide on top of the coil. Pull the handle down
gently at first making sure the coil is rotating into the book without missing
holes in the sheets or covers. Continue until the coil is past the left side of
the book by about one or two coils.
g)
h)
Page 4