Pathway LR Installers Guide - Manual (Page 13)

DMXPathfinder LR Installation & Assembly
12
T
ESTING THE
I
NSTALLATION
Once all connections are made and inspected for errors, you can power up the
DMXPathfinder LR modules in the equipment rack. With no DMX source
signals present, all eight red Isolated Power LEDs on the face of each Input
Module should be illuminated. On each Output Module, the green Processor
OK and Main 5V Power LEDs should be illuminated. If, in addition, the green
Crosspoint OK LED is on, this does not indicate a problem.
At this point, refer to DMXPathfinder LR Installation and User Guide, Chapter 2
– Communications Setup to get the PC talking to the Pathfinder. Once that has
been done, go to Chapter 5 – Diagnostics and Troubleshooting and perform the
health check and loopback tests on the installation.