頁面 10 – MIPRO ACT-72TC Rechargeable Narrowband Bodypack Transmitter User Manual

Page 10

Battery Removal and Installation

Pushing down both snap locks on the sides to

open battery compartment cover. Take out the

two batteries. (Figure 3)

Insert one charged 18500 rechargeable battery

into the battery compartment according to the

correct polarity (- and +) as shown in (Figure 4)

. Then close the battery compartment cover

tightly.

Caution

Remove the batteries if unused for a long period of

time to prevent battery leakage, corrosion and

causes possible damage to electronics.

(Figure 4)

(Figure 3)

Caution

Note: Transmitter cannot be powered on with

charged battery.

Method 1:

Ensure battery is inserted correctly with + top

side.

If battery is inserted correctly it could be due

to self battery protection mechanism. Insert the

transmitter into the charger to re-charge for

10-20 seconds to wake-up the battery. It

should work.

If charger cannot be used, reverse the battery

insertion for 10-20 seconds, wake up the

battery with correct polarity. It should work.

Method 2:

Power off the transmitter before open the

hinged cover. Press battery protection circuitry

reset button once to wake-up battery. Power on

the transmitter.

MODE

SET

Battery Protection

Circuitry Reset Button

Rechargeable Bodypack Transmitter