頁面 9 – MIPRO ACT-101 IR Remote-Controlled Single-Channel Diversity Receiver User Manual

Page 9

! Ensure it is plugged into an AC outlet.

! Ensure MT-101ACT transmitter microphone is fully charged.

! Aim the bottom of transmitter towards the ACT Port ( or ) .

! Press and hold the ACT button on the transmitter for at least 1 second to power on.

! Still red ACT Port Indicator Switch or Power Indicator denotes the power is on.

! ACT Port Indicator Switch or Power Indicator illuminates and dims denotes the

power is not turned on successfully. Repeat above steps until still red indicator
illuminates.

! Flashing ACT Port Indicator Switch or Power Indicator 4~5 times denotes

incorrect receiver and transmitter frequency band used.

! Once ACT Port Indicator Switch or Power Indicator illuminates red, transmitter

microphone is now ready to be turned on.

! Ensure MT-101ACT transmitter microphone is fully-charged.

! Turn on the Transmitter Power Switch .

! Speak into the microphone directly for amplification.

! Normal or Fully Charged Battery:

Red indicator illuminates and dims when Transmitter Power Switch is turned on.

! Low Power Battery:

Red indicator stays illuminate when Transmitter Power Switch is turned on.

! Drained Battery:

Red indicator does not illuminate when Transmitter Power Switch is turned on.

No Battery Inside or Battery Installed Incorrectly:

Red indicator does not illuminate when Transmitter Power Switch is turned on.

Wireless IR Remote Control Receiver

OPERATING INSTRUCTIONS

To Power ON ACT-101/ACT-101i Receiver:

To Power ON MT-101ACT Transmitter Microphone:

MT-101ACT Transmitter Microphone Battery Status:

! Aim the bottom of transmitter towards the ACT Port ( or ).

! Press and hold the ACT button on the transmitter for at least 1 second to power off.

! A dim ACT Port Indicator Switch or Power Indicator denotes the power is off.

! DO NOT touch the ACT Port Indicator Switch once is powered off.

! Each receiver and transmitter has an attached coded frequency label.

! Ensure that both the transmitter and receiver are operating on the same frequency

band in order to power on & off both receiver and transmitter.

! A flashing 4~5 indicator denote incorrect receiver and transmitter frequency band was

used.

! MIPRO's innovative design allows the versatile transmitter to sync any receiver

frequency within the same frequency band.

To Power OFF ACT-101/ACT-101i Receiver:

Different Transmitter and Receivers Frequency Bands:

This manual is related to the following products: