MIPRO ACT-72T Narrowband Bodypack Transmitter - Manual (Page 10)

Battery Removal and Installation
! Pushing down both snap locks on the sides to
open battery compartment cover. Take out the
two batteries. (Figure 3)
! Insert two fresh AA batteries (alkaline type is
recommended) into the battery compartment
according to the correct polarity (- and +) as
shown in (Figure 4). Then close the battery
compartment cover tightly.
Caution:
Remove the batteries if unused for a long period of
time to prevent battery leakage, corrosion and
causes possible damage to electronics.
(Figure 4) (Figure 3)
16 17
Bodypack Transmitter Bodypack Transmitter
Disassemble the Belt Clip
! Turn the bodypack transmitter
to the back side like the right
diagram.
! Pull open one side of the belt
clip and make it depart from
the slot of the bodypack
transmitter like the right
diagram.
! Then the other side of the belt
clip can be departed from the
other slot easily. The whole
belt clip is departed from the
bodypack transmitter
completely like the right
diagram.