Fagor FET-5112 - Manual (Page 15)

• Programming a washing cycle: Indicator lights and position of the selectors
— Turn the selector to choose the most suitable programme and washing temperature for
the type of fabric to be washed.
NB: Turning the selector to any position other than « » provides power to the machine.
«Wash» light flashing
(If you have selected rinse only or spin only,
it is the «Rinse» light that flashes
— Using the selector , choose:
- Either a suitable spin speed for your type of washing.
The spin speed is automatically restricted in the «synthetics», «delicates/woollens» and
«hand wash» programmes.
- Or drip dry.
The cycle will finish with a gentle spin at 100 rpm.
- Or stop with tub full of water.
Your machine will stop with the tub full of water before the final spin.
selector on
- Position «800» for example
- Position «100»
- Position
— Use the buttons to select any options you wish. Light(s) for the option(s) selected
— Select immediate start by pressing «start/pause» ... «Wash» light permanently lit
(The lights illuminate in succession to show
which phase the cycle is at)
— ... or use the selector to select starting delayed by 1 to 19 hours and then press «start/
pause» .
The lights flash in succession until the cycle
effectively starts
• Adding or removing an item during the cycle (impossible during spin) :
— Press the «start/pause» button to interrupt the cycle.
— Add or remove the items of laundry*.
— Press the «start/pause» button to restart the cycle.
(*) the time the lid remains locked depends on the temperature inside the machine and, for
safety reasons, may take several minutes if you are interrupting a cycle at more than 40°C.
NB: If you have selected a delayed start, you can access the drum instantly at any time in the
period before the washing cycle starts without having to interrupt and restart the cycle.
Light flashing
Light permanently lit
• Cancelling while programming, washing or during a pause:
Set the selector to the « » position.
This can be done at any time during the cycle or during programming, or even during a pause.
NB:
- In all cases, after cancelling you must reprogramme everything from the start.
- If you have cancelled during the washing phase, remember to empty the water, if necessary.
Selector set to « »
All the lights unlit
• End of the cycle:
NB: After spinning, some models automatically position the drum opening at the top to provide
easy access to the washing. This operation lasts at most 3 minutes.
— Then, the «Stop» light comes on permanently, indicating that the cycle is over.
Set the selector to the « » position.
You can now open the lid and remove your washing.
The «Stop» light is permanently lit
4 / PROGRAMMING YOUR MACHINE EN
15
• PROGRAMMING
Information:
All the buttons are on
microswitches and do not remain
depressed.
In any case, the «start/pause»
button cannot cancel a programme.
Important:
Before starting your machine,
check that the power cable is plugged
in and the water tap is open. Also
ensure that the drum doors are closed
correctly and the machine’s lid is shut.
During the «End of Cycle» phase,
any action on one of the controls (the
selectors or the buttons) returns you to
«Programming» mode. As a safety
measure, when the cycle is over, we
recommend that you unplug the power
cable and turn off the water tap.
1
4
2
For more details on the various functions, please refer to the sections «DETAILS OF THE PROGRAMMES» and «DETAILS OF THE OPTIONS».
Information:
After a power failure, when the power is restored, the washing cycle automatically resumes at the point where it was interrupted.
2
1 1
1
Nature of the washing and
the temperature
Start/Pause Cycle progress
Spin speed setting
Options Delayed start setting
3
5
5
5
5
5