Fagor TTP-2P - Manual (Page 8)

7
EN
using a qualified professional.
• The electrical safety of the appliance is
only guaranteed if it is connected to an
efficient earth installation, as foreseen in
applicable electrical safety regulations. If in
doubt, contact a qualified professional.
• The use of adaptors, multiple sockets and
or extension cables is not recommended.
Where it is not possible to avoid their use,
only adaptors or extensions that comply
with applicable safety regulations should
be used, and ensuring that the indicated
voltage limit is not exceeded.
• After removing the packaging, check that
the appliance is in perfect condition, if
in doubt, contact the nearest Technical
Support Service.
• Packaging elements (plastic bags,
polystyrene foam, etc.), should not be left
within the reach of children because they
can be dangerous.
• The manufacturer shall not be responsible
for any damages that may arise from
improper or inadequate use, or for repairs
conducted by nonqualified personnel.
• Do not touch the appliance with wet or
damp hands or feet.
• Keep the appliance separate from water
or other liquids, to avoid electric shock; do
not connect the appliance to the mains if it
is on a damp surface.
• Place the appliance on a dry, firm and
stable surface.
• Do not leave the appliance unattended
when it is turned on because it can be
dangerous.
• When removing the plug never pull on the
cable.
• Unplug the appliance before cleaning or
maintenance.
• In the event of fault or malfunction where
the appliance is not to be used, turn off
the appliance and do not attempt to repair.
If a repair is required, contact a Technical
Assistance Service authorised by the
manufacturer and request the use of
original spare parts.
• If the cable for this appliance is damaged,
contact an authorised Technical
Assistance Service for it to be replaced.
• Do not leave the appliance exposed to the
elements (rain, sun, ice, etc.).
• ATTENTION: Before using the unit for the
first time, remove stainless steel plastics
protection and clean using no abrasive
detergent. The set should not be put
in places near to fuels or susceptible
of deformation by heat. In case this is
not possible, one should coat the place
with a good thermical insulating and not
combustible material.
• Whenever the toaster is working, the
crumb tray should always be in its correct
place.
• If water is spilled over the set by accident,
it must be properly dried, so that it can be
usedagain.
• WARNING: During installation: Do not
place on any surfaces or near any walls,
partitions, kitchen cabinets or similar
unless they are made of non-flammable
material or have a suitable non-flammable
heat insulating coating, and always
observe fire prevention regulations.
• Before using this appliance for the first
time, read the following instructions
carefully and keep them for future
reference.
• Make sure that the mains voltage
corresponds to that indicated on the
appliance.
• In the event of incompatibility between
the mains socket and the appliance plug,
replace the socket with a suitable one,
1. DESCRIPTION
1. Crumb tray
2. Rack
3. Toaster body
4. Clip
5. Toast/timer selector
6. Element selector
Electromagnetic Compatibility: The
interference of this appliance has
been suppressed in accordance with
Electromagnetic Compatibility Directives.
This appliance complies with the EEC
directives relating to food contact materials.
2. SAFETY WARNINGS