beautypg.com

Before using your iron for the first time, Instructions for use 5. dry ironing – Fagor PL-2600 User Manual

Page 15

background image

14

off and do not try to repair it. Repairs
should only be carried out by a Technical
Assistance Service authorised by the
manufacturer. Always demand the use of
original spare parts. Any failure to follow
the above instructions could affect the
safe functioning of the appliance.

If you decide never to use the appliance

again, cut the lead, first ensuring that the
appliance is unplugged.

The user should never attempt to change

the cable. If, for any reason, the cable
requires changing, contact a Technical
Assistance Service authorised by the
manufacturer.

Never hold the appliance under the tap

to fill the water deposit.

Do not let the mains cable touch the hot

parts of the iron.

During use, the appliance becomes

extremely hot and can cause serious
burns. Always pick up the iron by the
handle and avoid contact with the
metallic parts and steam.

Do not turn the iron towards people

when it is expelling steam. This is
extremely dangerous.

Do not use the iron on very wet fabrics.
Do not store the iron in a horizontal

position (base down) whilst still hot. Wait
until it has cooled.

Do not mix stain-removers or similar

products on fabrics to be ironed.

Unplug the iron when not in use. Never

leave plugged in when not absolutely
necessary.

The appliance contains a safety device

which, when activated, interrupts the
working of the iron. To reactivate your
iron, contact an authorised Technical
Assistance Service.

If you decide never to use the appliance

again, remove the plug from the socket
and render it useless by cutting the
power cable.

• For greater protection, we recommend

installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.

4. BEFORE USING YOUR IRON FOR

THE FIRST TIME

Remove all stickers or protective labels
from the base and the body.
Unroll and straighten the electrical cable.
Follow the instructions given in the
"Self-cleaning" section in point "10 –
CLEANING
", in order to prepare your iron
for use.

INSTRUCTIONS FOR USE

5. DRY IRONING

1. Place the iron on a stable and heat-

resistant surface.

2. Turn the temperature selector knob (2) to

MIN (Fig. B).

3. Slide the steam control knob (7) to the

dry iron position (Fig. C).

4. Place the iron in an upright position,

resting it on the support base (10).

5. Plug it in and turn the temperature

selector to the desired position. The pilot
light (4) will come on.

6. When the iron has reached the selected

temperature, the pilot light (4) will switch
off. This pilot light may turn on and off
several times while you are ironing,
indicating the cycles of the thermostat.
Remember that if you change from
a higher to a lower temperature, the
pilot light (4) will remain off until the
temperature of the base (1) has dropped
to the selected level, at which point it will
come on again.

7. When you have finished, turn the

temperature selector to MIN and unplug
the iron. Leave to cool before cleaning
the exterior and storing.

When you are dry ironing, you can

use the spray option at any moment,
providing there is water in the deposit.
(See sections entitled "Spray" and
"Filling the deposit").