American Bicycle Security Company Rolling Rack Mini - Manual (Page 2)

American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
www.ameribike.com
Email: [email protected]
Product Rolling Rack
Capacity RRM2H: 4 Bikes
RRM3H: 6 Bikes
Materials 1.66” OD Schedule 40 pipe
Finishes An after fabrication hot dipped galvanized finish is our standard
option.
Installation
Methods
Solid concrete is the best base material for installation. Ask your
Rack representative which anchor is appropriate for your
application to ensure the proper anchors are shipped with your
rack. Be sure nothing is underneath the base material that could
be damaged by drilling.
3/8” anchors are shipped with the rack. Place the rack in the
desired location. Use a marker or pencil to outline the holes of
the flange onto the base material. Drill the holes in accordance
with the specifications shipped with the anchors. Make sure the
holes are at least 3” away from any cracks in the base material.
Use washers to level rack if necessary. Tap in anchors and follow
your specific anchor instructions provided with the rack.
Space Use
& Setbacks
Wall Setbacks:
For racks set perpendicular to a wall:
Minimum: 24”
Recommended: 36”
Street Setbacks:
Parallel to street: 96”
Perpendicular to street: 24”
Recommended: 36”
Rolling Rack Mini
(Anchors will vary according to
install surface)
Installation Steps:
Mark holes
1.
2.
Drill hole
3” Deep
Use washers to
level rack
3.
4.