Hi roller, American bicycle security company – American Bicycle Security Company Hi Roller User Manual
Page 2
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Hi Roller
Product
Hi Roller
Capacity
Hi2H: 4 Bikes
Hi3H: 5 Bikes
Hi4H: 6 Bikes
Hi5H: 7 Bikes
Materials
2.375” OD Schedule 40 Steel Pipe
Finishes
An after fabrication hot dipped galvanized finish is our standard
option.
250 TGIC powder coat colors, thermoplastic coating, PVC dip,
and stainless steel finishes are also available as alternate
options.
Our powder coat finish assures a high level of adhesion
and durability by following these steps:
1. Sandblast
2. Epoxy primer electrostatically applied
3. Final thick TGIC polyester powder coat
Stainless Steel: 304 grade stainless steel material finished
in either a high polished shine or a satin finish.
Installation
Methods
In ground mount is embedded into concrete base. Specify
in ground mount for this option.
Foot mount has two 6”x5” foot plates with 4 anchors
per foot. Specify foot mount for this option.
Space Use
& Setbacks
Wall Setback: A minimum of 27” should be left
between the wall and the long side of the rack. 36” is
the recommended setback.
Street Setback: For racks set parallel to the street,
a 96” setback is recommended. For racks installed
perpendicular to the street, 24” is the minimum setback.
36” is recommended.
Between Racks: For racks set next to each other, 24” is
the minimum setback. 36” is recommended.