Downtown rack – American Bicycle Security Company Downtown User Manual
Page 5
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Downtown Rack
*Tools Needed for Installation
9/16" socket set
(2) 4"x4"x28" (or larger) blocks
(4) bolts, nuts & washers for each rack.
If using tamper resistant nuts, install two
tamper-resistant & two standard nuts with
each rack.
Rail Mounted Installation
Installation Steps:
1.
2.
3.
4.
Lay out the two channel beams
where the rack will be placed.
Place both beams on top of the
two blocks of wood so that the
open part of the channel faces
the ground.
Place racks on beams so
holes in rack flanges line
up with beam slots.
Put bolts through Hoop
Rack flange holes &
beams so bolt head
faces up. HAND tighten
the nuts using new
flange nuts.
Once nuts are on, tip assembled
rack over & use a 9/16" socket to
tighten nuts. Before tightening
nuts, make sure the racks are
straight on beams. If using
tamper resistant nuts, use access
tool to tighten nuts. Do not over
tighten the tamper resistant
nuts. Tip rack upright.
Anchoring Rails:
To anchor the
rails to
concrete, place
3.75" wedge
anchor through
holes in the rail
into the
concrete.
Secure with nut.