Campus rack, American bicycle security company – American Bicycle Security Company Campus Rack User Manual
Page 2
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Campus Rack
Product
Campus Rack
Capacity
3-11 Bikes
Materials
Centerbeam: 3” OD 7 gauge tube
Ears: 1.25” OD 11 gauge tube.
All welds to be continuous MIG welds
Finishes
An after fabrication hot dipped galvanized finish is our standard
option.
250 TGIC powder coat colors, thermoplastic coating, PVC dip,
and stainless steel finishes are also available as alternate
options.
Our powder coat finish assures a high level of adhesion
and durability by following these steps:
1. Sandblast
2. Epoxy primer electrostatically applied
3. Final thick TGIC polyester powder coat
Stainless Steel: 304 grade stainless steel material finished
in either a high polished shine or a satin finish.
Installation
Methods
In ground mount is embedded into concrete base. Specify in
ground mount for this option.
Foot Mount has two 2.5”x6”x.25” feet with two anchors per
foot. Specify foot mount for this option.
Space Use
& Setbacks
Wall Setbacks:
For single sided models, leave 17” between the wall and the
rack center. For double sided models leave 80” between the wall
and the rack foot.
Street Setbacks:
For single sided models leave 36” between the street and
the rack center. For double sided units leave 78” between
the street and the rack foot.