AEG LAVAMAT W 730 - Manual (Page 41)

Installation and connection instructions
41
Water inflow
A pressure hose of 1.35m in length is supplied.
If a longer inflow hose is required, only a VDE-approved, complete set
of hoses with fitted hose screw connections offered by our Customer
Service is permissible.
– Hose sets in lengths of 2.2m, 3.5m and 5m are available for washing
machines without Aqua-Control.
– Hose sets in lengths of 2.0m, 2.9m and 3.5m are available for washing
machines with Aqua-Control.
Important! Never cut into pieces in order to extend the hoses!
3 Sealing rings are supplied either in the plastic
nuts of the hose screw connection or in the enc-
losed pack. Do not use other seals!
0 1. Connect the hose with the angled connection to
the machine.
Important!
– Do not lay the inlet hose verti-
cally downwards, instead run it
to the right or left as shown in
the diagram.
– Tighten the hose screw connec-
tion only by hand.
2. Connect the hose with the
straight connection to a water valve with a
screw thread R 3/4 (inches).
Important! Only tighten the screw connection
manually.
3. By slowly opening the water valve before
putting the washing machine into operation,
check that the connection is free of leaks.