Advanced Technology VeneerBric - Manual (Page 2)

ATI‐VBII Revision 0 Effective: 11/4/2011
Advanced Technology, Inc (800) 849‐1320 www.advtechnology.com
Page 2 of 4
5. Hang the sheet.
The sheet can be rolled or folded in half and held, with the print facing the inside. Do not
crease the sheet. Starting at the ceiling, carefully unfold or unroll the top portion of the first
sheet and gently place the side edge of the strip along the measured line. Place a
thumbtack in each corner at the top of the sheet to hold it in place.
When the sheet is in the right position, drop down the bottom portion and gently smooth
the sheet against the wall with your hands, beginning at one edge and working your way
across. Use a smoothing brush, damp sponge, or J-roller to smooth out any air bubbles.
Use a seam roller to gently smooth down the edges of the sheet.
6. Smooth the corners.
At the corners, measure from the last sheet to the corner. Cut the next sheet to that width.
Apply paste to the wall as mentioned in section 4.
NOTE: Inside or outside corner trim pieces might be necessary to properly finish these
areas.
Apply the sheet on the wall, making sure to smooth it totally into the corner for interior
corners.
7. Repeat hanging the sheets around the room.
Continue hanging the next sheet, taking care to match the pattern, removing any creases
or air bubbles, securing the seams, and cleaning the paste off the sheet.
8. Replace light switch and receptacle plates.
MAINTENANCE
The following materials and instructions are recommended for cleaning VeneerBric:
•
Lint brush
• 2 Small bowls
• Water
•
Liquid clothes soap
• 3 Hand towels
1. Brush the fabric with the lint brush. This will help to remove lint, dust, dirt and debris and
soften any hard spots.
2. Dab at any wet spots with a hand towel. Do not rub, as this can spread the spill or the
stain and make it more difficult to remove.
3. Fill a small bowl with water and dip the end of the second hand towel into it. Wring out any
excess moisture.
4. Dab the wet hand towel at any spot of stain on the VeneerBric. Do not rub.
5. Pour a small amount (silver dollar sized amount) of liquid clothing detergent into the
second bowl.
6. Dip the end of the wet hand towel into the detergent and dab at the stain or spot, until it is
removed. Do not rub.
7. Dip the end of the third hand towel into water and wring out any excess moisture.
8. Dab the wet hand towel over the area you just cleaned with detergent. Repeat until the
soap is gone.
9. Dab at the wet spot with the dry end of the hand towel until it has dried.