Wittco 200-4R-BI User Manual
Page 5

DRAWER & CHIP WARMERS
F-41015 (03-14)
4
TRIM KIT INSTALLATION
Models: 200-1R-BI-C, 200-2R-BI-C,
200-3R-BI-C, 200-4R-BI-C, 200-1R-BI,
200-2R-BI, 200-3R-BI, 200-4R-BI.
Built-in Drawer Warmers come with a
“trim kit.” Follow the general installation
instructions in the “Installation &
Operation Manual” regarding
Unpacking, Electrical Requirements,
Cleaning, and Removal of Vinyl
Protection Film.
1.
Remove the drawer assemblies
from
the
cabinet.
a.
Open drawer to full extension.
b.
Lift up drawer and pull out
slightly.
c.
Tilt down drawer and pull out.
2.
Place Trim Kit flush with the front
of the Drawer Warmer.
3.
Trim Kit has 4 mounting holes.
There are two holes on the
bottom and two holes on the top.
MOUNTING HOLES
4.
Using #8 Tech Screws that
are included, fasten the four
screws into the mounting holes.
The screws are self-tapping and no
pilot holes are necessary.
5.
Connect Drawer Warmer to
electrical power supply per your
local electrical code.