Wittco 1401 - Manual (Page 19)

1001 & 1401 OVEN MANUAL F-41206 (12-12)
18
LOCKOUT / TAGOUT PROCEDURE
Always perform the Lockout / Tagout Procedure
before removing any sheet metal panels or attempting to service
this equipment.
The Lockout / Tagout Procedure is used to protect personnel working on an electrical
appliance. Before performing any type of maintenance or service on an electrically
operated appliance, follow these steps:
1.
In electrical box, place unit’s circuit breaker into OFF position.
2.
Place a lock or other device on electrical box cover to prevent someone from
placing circuit breaker ON.
3.
Place a tag on electrical box cover to indicate that unit has been disconnected for
service and power should not be restored until tag is removed by maintenance
personnel.
4.
Disconnect unit power cord from electrical outlet.
5.
Place a tag on cord to indicate that unit has been disconnected for service and
power should not be restored until tag is removed by maintenance personnel.
SERVICE & PARTS INFORMATION
To obtain Service and Parts information concerning this model, contact Wittco Service
Department at the address listed on the front cover of this manual or refer to our
website:
www.wittco.com for a complete listing of Authorized Service and Parts depots.
Customer Service 1-414-434-4713
Technical Service 1-414-434-4716
Service Parts 1-414-434-4716
When calling for service, have the model number and serial number available.