Westwood Design Waverly Convertible Crib (WA-CR-8601NR) - Manual (Page 10)

Day Bed Conversion
Required Hardware
6 x Allen Bolt, 1-1/8” Long (P)
Allen Wrench (R)
6 x Cap Nut (Q)
Allen Bolt (P)
Cap Nut (Q)
A. Using the allen wrench, remove the six bolts attaching the footboard to the
crib and remove the footboard.
B. Screw the removable feet (included with the crib) into the bottom of the crib
sides.
C. Adjust the spring to its lowest position, following the procedure shown in these
instructions.
D. Insert the allen bolt (P) through the hole in the corner post, and thread it into
the cap nut as shown. Tighten securely using the allen wrench.
E. Repeat with the other 5 holes.
Removable Foot (C)