Vaddio ProductionVIEW Rack Enclosure - Manual (Page 2)

ProductionVIEW Rack Enclosure
ProductionVIEW Rack Enclosure - Document 341-722 Rev. B Page 2 of 4
ProductionVIEW Rack Enclosure Sliding Shelves
ProductionVIEW Sliding Shelf Includes:
 One (1) Sliding Shelf
 Two (2) Angle Brackets (left and right) for mounting the ProductionVIEW or Precision Camera Controller
 Four (4) 8-32 x 3/8” screws
 Eight (8) 10-32 x .313” black oxide screws
 Two (2) 8-32 x 3/8” flat head screws
 Two (2) ¼” flat washers
 Six (6) 8-32 Keps nuts
Installing the Sliding Shelf
1. Locate the two (2) 8-32 flat head screws, two (2) flat
washers, and two (2) Keps nuts.
2. Loosen wing nuts on the “L” brackets of the sliding shelf.
3. Lay sliding shelf into bottom of enclosure.
4. Slide flat head screw into one hole on the back side of the rack console.
5. Place a washer in between the rack enclosure side panel and the L bracket (see below).
6. Slide the L-shaped tab attached to the wing nut onto the flat head screw, and then tighten the Keps nut onto
the flat head screw.
P/N: 998-5000-210 ProductionVIEW Sliding Shelf
Fits Models ProductionVIEW FX, ProductionVIEW HD,
ProductionVIEW HD-SDI, ProductionVIEW HD MV,
ProductionVIEW HD-SDI MV & ProductionVIEW Super Joystick
P/N: 998-5000-211 ProductionVIEW Precision
Camera Controller Sliding Shelf
Sliding Shelf
Diagram showing the back of the
Sliding Shelf installation (top view)